This is a Automatic WaterMaker Control system that can be configured to operate any manual AC, DC or engine driven unit. This unit is PLC Based and all replacement components (if needed) can be purchased over the counter or on-line.

Contact qwwinc@alltel.net or call 336-924-8966 to discuss configuration. This panel is available with all Quality Water Works WaterMakers for an additional $1495.00

A push of the start button will start the booster pump, upon reaching desired booster pressure , the high pressure pump will start and the TDS monitor/Diverter will measure the quality of the freshwater being made and direct it to the storage tank once desired quality set point is met (the high pressure pump won't start if prefilters are dirty or it will stop if filters become dirty during operation) . The WaterMaking mode will continue until the stop button is pushed of the Storage tank is full (optional float switch required for this feature). When enough water has been made, simply push the stop button. It is recommended that all watermakers be flushed with fresh water after each watermaking session. The unit is flushed by simply pushing the flush button. The controller will flush the High pressure pump, membrane and control system, Half-way through the flush cycle the controller will flush the pre-filters, booster pump and sea strainer. The unit is now ready for the next watermaking session. A User programable Automatic flush module is included with the system for unattended system flushing instead of membrane Pickling. There is also a preservative addition mode incorporated into the design  Contact qwwinc@alltel.net for more information. Web-site www.qwwinc.com.