Air Conditioning
E&B Heating and Air Conditioning specializes in home comfort. We offer a solution for all types of air conditioning concerns and problems.
We sell, install, repair, and service all major brands of the following:
Mini Splits
- Air conditioning compressors (outside unit)
- Air conditioning, air handlers and evaporator coils (inside unit)
- Other cooling and home comfort systems
Air Conditioning
- CONDENSER COIL will be cleaned. Value to you - Dirty condenser coils raise refrigerant pressure higher than needed, increasing your electrical bill.
- EVAPORATOR COIL will be inspected and cleaned if accessible. Value to you - Evaporator coils become dirty because air filters only collect a portion of the particles in the air. Even a small amount of dirt can decrease efficiency and increase operation compressor failure. Customer should replace with properly sized air filter every month.
- BLOWER WHIEELS will be inspected and cleaned as necessary. Value to you - Dirty blower wheels reduce air flow, causing longer operating time and increased cost. This problem can lead to lost comfort and compressor failure.
- REGRIGERANT CHARGE checked. Value to you - A low or high refrigerant charge can easily go unnoticed and increase operating cost. An improper charge can cause compressor shutdown.
- AIR FILTER will be inspected and replaced for club members. Value to you - A restricted air filter can cause your air conditioning unit to waste energy and shorten the compressor’s life.
- BELTS AND PULLEYS will be inspected and adjusted as required. Value to you - Loose belts and worn pulleys decrease air flow, increase operating costs and shorten the compressor’s life. Belts crack and break with age.
- LUBRICATION of motors and bearings. Value to you - Improperly lubricated rotating equipment will eventually fail.
- THERMOSTAT will be checked for proper operation. Value to you - Improperly calibrated thermostats allow the unit to run longer than necessary. Every degree your air conditioning operates below 78 degrees can add between five and eight percent to the cost of cooling.
- CONTROLS & SAFETIES will be inspected and tested. Value to you - Controls and safeties that do not function properly can increase operation cost and cause other components to fail.
- MOTORS will be cleaned and inspected. Value to you - Dirty motors are less efficient and will fail sooner.
- CAPACITORS will be inspected. Value to you - Dirty motors are less efficient to compressor and motor failure.
- CONDENSATE DRAIN will be checked and cleaned. Value to you - Algae can plug a condensate drain which can cause expensive water damage.
- CRANKCASE HEATER will be operationally checked. Value to you - Crankcase heaters that do not work can lead to a compressor failure.
- RELAYS AND CONTACTORS will be inspected. Value to you - Worn contacts and loose wire connections can lead to a motor or compressor failure.
- UNIT DISCONNECT will be inspected. Value to you - A worn or overheated disconnect blows fuses and is dangerous.
- UNIT WIRING will be inspected and loose connections tightened. Value to you - Loose connections can lead to a motor or compressor failure.
- TEMPERATURES AND PRESSURE will be taken and recorded. Value to you - An accurate record of your equipment’s vital data can indicate potential problems, which can be eliminated. A record will be kept which may reduce emergency service time.
- DUCT WORK will be checked for leaks at the unit. Value to you - Duct leaks may exist from the time it was installed and insulation can fall off. Unrepaired duct work problems can increase operating costs by 30% or more. Accessible duct work will be inspected at least once during the first year of the agreement.